Free Cisco and NetApp FlexPod NS0-175 Ultimate Study Guide (Updated 277 Questions)
Get to the Top with NS0-175 Practice Exam Questions
NEW QUESTION 123
You need to design a FlexPod Datacenter solution that will support data replication between two data centers. The networking hardware must support the ability to extend Layer 2 Ethernet traffic over a routed Layer 3 infrastructure using Overlay Transport Virtualization (OTV), support Fibre Channel over Ethernet (FCoE), and support In Service Software Upgrades (ISSUs).
Which Cisco Nexus series hardware would you include in this design?
- A. Cisco Nexus 7000
- B. Cisco Nexus 9000
- C. Cisco Nexus 5000
- D. Cisco Nexus 3000
Answer: D
NEW QUESTION 124
Which statement is true about the capabilities of Cisco UCS Manager?
- A. It supports Cisco UCS B-Series blades and not C-Series rack servers.
- B. It uses only manual discovery to detect, inventory, manage, and provision system components.
- C. It provides policy-driven management to programmatically control server, network, and storage resources.
- D. It manages servers up to 50 blades per UCS domain.
Answer: A
NEW QUESTION 125
Which command would you use to see the available option choices for the show config.http.acl command?
- A. help config.acl
- B. help
- C. config.acl help
- D. show config.http.acl.?
Answer: D
NEW QUESTION 126
When using Virtual Port Channel (vPC) on a Nexus 5500 switch, what protocol is responsible for synchronization of configuration, spanning tree, MAC and VLAN information?
- A. LACP
- B. Spanning Tree Protocol (STP)
- C. Fibre Channel over Ethernet (FCoE)
- D. Cisco Fabric Services over Ethernet (CFSoE)
Answer: D
NEW QUESTION 127
Which of the following statements most accurately describes what would occur if she requested for www.microsoft.com considering the following ACL policies, assuming user Johnny is a member of the Engineering group?
- deny group Engineering and smartfilter gambling
- auth any
- allow group Execs
- deny any
- A. The request is denied because of a Smartfilter match.
- B. The request is denied.
- C. The request is successful but redirected to a gambling website.
- D. The request is successful.
Answer: B
NEW QUESTION 128
You are designing a FlexPod Datacenter solution that supports Cisco Application Centric Infrastructure (ACI) with VMware vSphere. The customer wants to boot from SAN with FCoE-based LUNs.
What is the correct deployment topology in this situation?
- A. Connect the storage FCoE target ports to the UCS Fabric Interconnects and load the UCS fNIC driver during the installation.
- B. Connect the storage FCoE target ports to the Nexus 5000 series switch and load the UCS fNIC driver during the installation.
- C. Connect the storage FCoE target ports to the Nexus 9000 series switch and load the UCS fNIC driver during the installation.
- D. Connect the storage FCoE target ports to the Chassis Fabric Extender and load the UCS fNIC driver during the installation.
Answer: A
NEW QUESTION 129
A customer wants to refresh their FlexPod solution by moving from 10 Gbps to 40 Gbps networking. They use FCoE to boot from SAN.
In this scenario, which statement is true?
- A. FCoE is supported for 40 Gbps adapters
- B. FCoE is supported for 32 Gbps adapters
- C. FCoE is supported on only 10 Gbps unified adapters
- D. FCoE is supported for 25 Gbps adapters
Answer: A
NEW QUESTION 130
You are working with a customer on a new FlexPod solution. The customer advises you that they want a single point of contact for support issues.
In this scenario, which two support solutions should you offer the customer? (Choose two.)
- A. Cisco SmartNet Total Care
- B. NetApp Solution Support for FlexPod
- C. Cisco Solution Support
- D. NetApp SupportEdge Expert
Answer: A,B
NEW QUESTION 131
Which of the following commands are used for running automated diagnostic analysis routines?
- A. diag list
- B. diag dump
- C. netstat -d
- D. ifstat -a
Answer: B
NEW QUESTION 132
A customer is unhappy with their current data center infrastructure. They want to purchase a FlexPod system to replace it. The customer asks you to help them understand the benefits of Solution Support to determine which support model would suit them best.
In this scenario, which three statements are correct? (Choose three.)
- A. Solution Support is a lower-cost support option
- B. There is no need to diagnose the problem before you call support
- C. You have a single point of contact for all cases
- D. Customers do not need to open tickets; all issues are automatically reported
- E. Issues are solved by solution experts
Answer: A,C,E
NEW QUESTION 133
The ___ command is used to run automated diagnostic analysis routines.
- A. diag list
- B. diag dump
- C. netstat -d
- D. ifstat -a
Answer: B
NEW QUESTION 134
A customer wants to deploy a FlexPod solution that involves directly connecting the NetApp AFF storage using the FCoE protocol to the Cisco UCS Fabric Interconnects.
In this scenario, which Cisco UCS Fibre Channel mode would be used to accomplish this task?
- A. access mode
- B. end host mode
- C. trunk mode
- D. switching mode
Answer: D
NEW QUESTION 135
Exhibit 1:
Exhibit 2:
Referring to the exhibit, UCS Fabric Interconnect 6300-A fails as shown in Figure 1. Due to the storage LIF configuration, after UCS Fabric Interconnect 6300-A is restored, traffic flows as shown in Figure 2.
To enable this capability, on which two UCS port types should storage VLANs be accessible? (Choose two.)
- A. uplink ports
- B. fabric ports
- C. switch ports
- D. appliance ports
Answer: A,D
NEW QUESTION 136
You are sizing a FlexPod Virtual Desktop solution for a customer with 500 virtual desktops in a shared Remote Desktop Services (RDS) topology.
In this scenario, which Cisco best practice should you use?
- A. You should avoid multiple vCPUs per individual virtual machine
- B. You should avoid placing more than 20 users per physical host
- C. You should avoid changing the virtual host disk queue depth
- D. You should avoid over-committing physical CPU resources for virtual machines
Answer: D
NEW QUESTION 137
Clustered Data ONTAP 8.1 or later provides what four storage efficiency features? (Choose four.)
- A. deduplication
- B. transparent files
- C. MetroCluster
- D. FlexClone
- E. compression
- F. thin provisioning
Answer: A,D,E,F
NEW QUESTION 138
When configuring a FlexPod environment for iSCSI boot with Cisco UCS, which item should be preconfigured?
- A. All zoning should be configured
- B. IQN and IP address of target
- C. Zonesets should be created
- D. WWPN Pools
Answer: B
NEW QUESTION 139
......
Pass Network Appliance NS0-175 exam - questions - convert Tets Engine to PDF: https://examsforall.lead2passexam.com/NetworkAppliance/valid-NS0-175-exam-dumps.html